Jump to content
Danerec

Installing a shield handle

Recommended Posts

The heater shield I ordered back in October finally arrived. I realized that the leather straps in the back are not adjustable, and the one that my hand would grip is extremely loose. I would like to replace it with a solid handle, but I know that would mean putting a screw/bolt through the shield and having the end of it showing on the face of the shield. I was wondering if someone could help me do this, and also if the screw/bolt heads are rounded like in this picture, and the edge is covered, do I have to cover the face in foam?

Share this post


Link to post
Share on other sites

As long as whatever fastener you use isn't dangerous to weapons or people, it's fine. Exposed carriage bolt heads have been the norm at KoN for ten years, they're fine.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×